Zebra DS9908 - Page 421

Parameter Defaults
421
Function Key Mapping N/A N/A Disable 239
Simulated Caps Lock N/A N/A Disable 239
Convert Case N/A N/A None 240
USB Static CDC N/A N/A Enable 241
TGCS (IBM) USB Beep Directive N/A N/A Ignore 241
TGCS (IBM) USB Barcode
Configuration Directive
N/A N/A Ignore 242
TGCS (IBM) USB Specification
Version
N/A N/A Version 2.2 242
SSI Host Parameters
Select SSI Host N/A N/A N/A 255
Baud Rate 156 9Ch 9600 255
Parity 158 9Eh None 257
Check Parity 151 97h Disable 258
Stop Bits 157 9Dh 1 258
Software Handshaking 159 9Fh ACK/NAK 259
Host RTS Line State 154 9Ah Low 260
Decode Data Packet Format 238 EEh Send Raw Decode Data 261
Host Serial Response Timeout 155 9Bh Low - 2 Seconds 262
Host Character Timeout 239 EFh Low - 200 msec 263
Multipacket Option 334 F0h 4Eh Multipacket Option 1 264
Interpacket Delay 335 F0h 4Fh Minimum - 0 msec 265
Event Reporting
Decode Event 256 F0h 00h Disable 266
Boot Up Event 258 F0h 02h Disable 267
Parameter Event 259 F0h 03h Disable 268
RS-232 Host Parameters
RS-232 Host Types N/A N/A Standard 274
Baud Rate N/A N/A 9600 276
Parity N/A N/A None 277
Table 29 Parameter Defaults (Continued)
Parameter
Parameter
Number
1
SSI
Number
2
Default
Page
Number
1. Parameter number decimal values are used for programming via RSM commands.
2. SSI number hex values are used for programming via SSI commands.