Zebra DS9908 - Page 422

Parameter Defaults
422
Stop Bits N/A N/A 1 Stop Bit 277
Data Bits N/A N/A 8-bit 278
Check Receive Errors N/A N/A Enable 278
Hardware Handshaking N/A N/A None 279
Software Handshaking N/A N/A None 281
Host Serial Response Timeout N/A N/A 2 Seconds 283
RTS Line State N/A N/A Low RTS 284
Beep on <BEL> N/A N/A Disable 284
Intercharacter Delay N/A N/A 0 msec 285
Nixdorf Beep/LED Options N/A N/A Normal Operation 286
Barcodes with Unknown
Characters
N/A N/A Send Barcode With
Unknown Characters
286
IBM 468X/469X Host Parameters
Port Address N/A N/A None 291
Convert Unknown to Code 39 N/A N/A Disable 292
RS-485 Beep Directive N/A N/A Ignore 292
RS-485 Barcode Configuration
Directive
N/A N/A Ignore 293
IBM-485 Specification Version N/A N/A Original Specification 293
Keyboard Wedge Host Parameters
Keyboard Wedge Host Type N/A N/A IBM AT Notebook 297
Barcodes with Unknown
Characters
N/A N/A Send Barcodes with
Unknown Characters
297
Keystroke Delay N/A N/A No Delay 298
Intra-keystroke Delay N/A N/A Disable 298
Alternate Numeric Keypad
Emulation
N/A N/A Enable 299
Quick Keypad Emulation N/A N/A Enable 299
Simulated Caps Lock N/A N/A Disable 300
Caps Lock Override N/A N/A Disable 301
Table 29 Parameter Defaults (Continued)
Parameter
Parameter
Number
1
SSI
Number
2
Default
Page
Number
1. Parameter number decimal values are used for programming via RSM commands.
2. SSI number hex values are used for programming via SSI commands.