Zebra DS9908 - Page 423

Parameter Defaults
423
Convert Case N/A N/A Do Not Convert 301
Function Key Mapping N/A N/A Disable 302
FN1 Substitution N/A N/A Disable 302
Send Make and Break N/A N/A Send Make and Break Scan
Codes
303
OCR Programming Parameters
OCR-A 680 F1h A8h Disable 307
OCR-A Variant 684 F1h ACh OCR-A Full ASCII 308
OCR-B 681 F1h A9h Disable 309
OCR-B Variant 685 F1h ADh OCR-B Full ASCII 310
MICR E13B 682 F1h AAh Disable 314
US Currency Serial Number 683 F1h ABh Disable 315
OCR Orientation 687 F1h AFh
0
o
315
OCR Lines 691 F1h B3h 1 317
OCR Minimum Characters 689 F1h B1h 3 317
OCR Maximum Characters 690 F1h B2h 100 318
OCR Subset 686 F1h AEh Selected font variant 318
OCR Quiet Zone 695 F1h B7h 50 319
OCR Template 547 F1h 23h 54R 319
OCR Check Digit Modulus 688 F1h B0h 1 329
OCR Check Digit Multiplier 700 F1h BCh 121212121212 329
OCR Check Digit Validation 694 F1h B6h None 330
Inverse OCR 856 F2h 58h Regular 336
OCR Redundancy 1770 F8h 06h EAh Level 1 337
Intelligent Document Capture (IDC) Parameters
IDC Operating Mode 594 F1h 52h Off 343
IDC Symbology 655 F1h 8Fh 001 344
IDC X Coordinate 596 F4h F1h 54h -151 345
IDC Y Coordinate 597 F4h F1h 55h -050
Table 29 Parameter Defaults (Continued)
Parameter
Parameter
Number
1
SSI
Number
2
Default
Page
Number
1. Parameter number decimal values are used for programming via RSM commands.
2. SSI number hex values are used for programming via SSI commands.