Cisco Nexus 7000 Series - Page 25

New and Changed Information
xxv
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
NetFlow hardware The show hardware ip command has been
changed to the show hardware flow command.
6.0(1) show hardware flow
Flexible Netflow The show flow monitor command has been
changed to the show flow-sw monitor command.
6.0(1) show flow sw-monitor
Callhome Added the ability to send HTTP messages
through an HTTP proxy server.
5.2(1) transport http proxy enable
transport http proxy server
EEM event correlation Added support for multiple event triggers in a
single EEM policy.
5.2(1) tag
Logging Added the ability to support descriptions for
physical Ethernet interfaces and subinterfaces in
the system message log.
5.2(1) logging message interface type
ethernet description
Network Time Protocol Changed the [no] ntp enable command to the
[no] feature ntp command.
Added the ability to configure the device as the
NTP authoritative server, enabling it to distribute
time even if it is not synchronized to an existing
time server.
5.2(1) feature ntp
ntp master
Precision Time Protocol Added support for PTP is a time synchronization
protocol nodes distributed across a network. This
protocol provides greater accuracy than other
time synchronization protocols.
5.2(1) feature ptp
ptp announce
ptp delay-request minimum
interval
ptp domain
ptp priority1
ptp priority1
ptp priority2
ptp source
ptp sync interval
ptp vlan
show ptp brief
show ptp clock
show ptp clock
foreign-masters-record
show ptp corrections
show ptp parent
show ptp port
show ptp time-property
SPAN Monitor Added the ability to configure MTU truncation,
the source rate limit, and the multicast best effort
mode for each SPAN session and the ability to
configure MTU truncation and the multicast best
effort mode for each ERSPAN session.
5.2(1) mtu
multicast best-effort
rate-limit
Table 1 New and Changed Features for Release 6.x (continued)
Feature Description
Changed
in
Release Where Documented