Configuring ACS in Wizard Mode
86
Table 5-3: Wizard > Enabled protocols for each security profile shown with a check mark.
1-The Default security profile parameters is the same as Moderate profile.
The first step in configuring your AlterPath ACS is to select a Security
Profile. One of the following situations is applicable when you boot the ACS
unit.
1. ACS is starting for the first time, or after a reset to factory default.
In this situation when you boot ACS and login as an administrator to the
Web Manager, a security warning dialog box appears. The Web Manager
is redirected to “Step1: Security Profile” in the Wizard mode. Further
navigation to other sections of the Web Manager is not possible without
selecting or configuring a Security Profile. Once you select or configure a
Security Profile and apply the changes, ACS Web Manager restarts for the
security configuration to take effect.
2. ACS firmware is upgraded and the system is restarting with the new
firmware.
In this situation the ACS was already in use and certain configuration
parameters were saved in the flash memory. In this case ACS
automatically retrieves the “Custom Security Profile” parameters saved in
the flash memory and behaves as it was a normal reboot.
3. ACS is restarting normally.
In this situation ACS detects the pre-defined security profile. You can
continue working in the Web Manager.
Other Services Secure Moderate Open
Default
1
Custom
SNMP
3
RPC
3
ICMP
333
FTP
IPSec
User Configurable
To Next Page
Loading...
