Cyclades AlterPath ACS - Table 1-2: Enabled Services to Access the ACS under each Security; Table 1-3: Enabled Services to Access the Serial Ports under each

AlterPath ACS Installation, Administration, and User’s Guide 13
As an additional security measure, all serial ports are disabled by default,
which allows the administrator to enable and assign individual ports to users.
The following table shows the available security profiles and the active
services under each profile. See “Security Profiles” on page 236 for detailed
information and procedures.
Table 1-2: Enabled services to access the ACS under each security profile.
1-The Default security profile parameters is the same as Moderate profile.
Table 1-3: Enabled services to access the serial ports under each profile.
1-The Default security profile parameters is the same as Moderate profile.
Access to ACS Secure Moderate Open
Default
1
Custom
Telnet
3
SSHv1
333
SSHv2
33 33
Allow SSH root access
333
HTTP
333
HTTPS
33 33
HTTP redirection to HTTPS
33
Access to Serial Ports Secure Moderate Open
Default
1
Custom
Console (Telnet)
333
Console (SSH)
33 33
Console (Raw)
333
Serial Port Authentication
3
Bidirect (Dynamic Mode
Support)
333
User Configurable
User Configurable