AlterPath ACS Installation, Administration, and User’s Guide 335
Replacing the Battery
Electrostatic Discharge (ESD) Precautions
When handling any electronic component or assembly, you must observe the
following antistatic precautions to prevent damage.
• Always wear a grounded wrist strap when working around printed circuit
boards,
• Treat all assemblies, components, and interface connections as static-
sensitive,
• Avoid working in carpeted areas, and
• Keep body movement to a minimum while removing or installing boards
to minimize the buildup of static charge.
Replacing the Battery
Caution: There is the danger of explosion if the battery is replaced incorrectly. Replace
the battery only with the same or equivalent type recommended by the
manufacturer. Dispose of used batteries according to the manufacturer's
instructions.
Caution: Bei Einsetzen einer falschen Batterie besteht Explosionsgefahr. Ersetzen Sie
die Batterie nur durch den gleichen oder vom Hersteller empfohlenen
Batterietyp. Entsorgen Sie die benutzten Batterien nach den Anweisungen des
Herstellers.
FCC Warning Statement
The AlterPath ACS has been tested and found to comply with the limits for
Class A digital devices, pursuant to Part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the Installation & Service Manual,
may cause harmful interference to radio communications.
To Next Page
Loading...
