AlterPath ACS Installation, Administration, and User’s Guide 275
Figure 10-23:Expert > Ports > Physical Ports > Data Buffering
There are different fields on this form depending on whether one or both
options are enabled. The form displays “Enable Data Buffering” and “Buffer
to Syslog” options.
If “Enable Data Buffering” is active, the form displays different fields
depending on whether “Local” or “Remote” are selected from the
“Destination” menu.
If “Buffer to Syslog” is checked, data buffer files are sent to the syslog server.
Note: Go to Wizard > Step 5:System Log, or Expert > Network > Syslog to set up a
syslog server.
The following form shows both checkboxes (“Enable Data Buffering” and
“Buffer to Syslog”) and the “Local” destination selected.
To Next Page
Loading...
