AlterPath ACS Installation, Administration, and User’s Guide 53
Connecting AlterPath PM IPDUs
The following table lists the related tasks on connecting IPDU units and
managing power.
T To Daisy-Chain AlterPath PMs to the ACS
This procedure assumes that you have one AlterPath PM connected to a serial
port on the ACS.
1. Connect one end of a UTP cable with RJ-45 connectors to the “OUT” port
of the AlterPath PM that is connected to the serial port on ACS.
2. Connect the other end of the cable to the “IN” port of the next AlterPath
PM.
3. Repeat Steps 1 and 2 until you have connected the desired number of
AlterPath PMs.
Table 2-4: Tasks Related to Connecting AlterPath PMs
Task Where Documented
Configure serial ports for power
management protocol.
“To Configure a Serial Port for IPDU or
IPMI Power Management” on page 285
How the administrators perform IPDU power
management using the Web Manager
“IPDU Power Mgmt.” on page 126
How the regular users manager power outlets
using the Web Manager
“To Close an SSH Session” on page 62
Connect the AlterPath PM to the ACS unit,
and daisy-chain multiple PM units.
“To Daisy-Chain AlterPath PMs to the ACS”
on page 53
Configure users for IPDU power
management
“To Configure Users to Manage Power
Outlets on IPDUs” on page 134
Configure servers for IPMI power
management while connected.
“To Delete, Add, or Edit an IPMI Device to
Enable or Disable IPMI Power
Management” on page 148
To Next Page
Loading...
