AlterPath ACS Installation, Administration, and User’s Guide 215
Network
T
To Configure Static Routes [Expert]
See Table 8-18 on page 207 for the field descriptions.
1. Go to Network > Static Routes
The Static Routes form appears.
• To edit a static route, select a route from the “Static Routes” list, and
then select the “Edit” button.
• To add a static route, select the “Add” button from the form.
The system invokes the “New/Modify Route” dialog box.
2. Choose “Default”, “Network”, or “Host” from the “Route” pull-down
menu.
3. If you selected “Network, do the following steps.
a. Enter the IP address of the destination network in the “Network IP”
field.
b. Enter the netmask of the destination network in the “Network Mask”
field.
4. If you selected “Host,” type the IP address of the destination host in the
“Host IP” field.
5. Select “Gateway” or “Interface” from the “Go to” pull-down menu and
enter the address of the gateway or the name of the interface in the
adjacent field.
6. Click “apply changes.”
To Next Page
Loading...
