Installation and Configuration
44
• DNS IP address
• Gateway IP address
• Network mask
• NTP server’s IP address (if you are using a time/date server)
Performing Basic Network Configuration Using the wiz
Command
The following procedure assumes that a hardware connection is made
between the ACS’s console port and the COM port of a computer.
T To Log Into ACS Through the Console
From your terminal emulation application, log into the console port as
root.
Warning: For security reasons, it is strongly recommended that you change the default
password “tslinux” as soon as possible. To change the default password, enter
the “passwd” command at the prompt, and enter a new password when
prompted.
Note: The following Security Advisory appears the first time ACS is accessed, or
after a reset to factory default parameters.
If you are upgrading the
firmware on ACS, the previously configured security parameters are
retained in the flash memory and the below message does not appear.
ACS login: root
Password: tslinux
To Next Page
Loading...
