AlterPath ACS Installation, Administration, and User’s Guide 193
Network
Table 8-12: Expert > Tasks for Configuring SNMP
Services
Selecting Network > Services brings up the form shown in the following
figure.
Figure 8-20: Expert > Network > Services
Depending on the security requirements of your site, you may want to enable
or disable the daemons that support the following types of connections:
• Telnet [enabled by default]
• SSH [enabled by default]
• SNMP [enabled by default]
• IPSec
Each of these services is required when Telnet, SSH, SNMP, or VPN are
configured, as described in the following table.
Task Where Documented
To activate the SNMP service. See “Services” on page 193
To configure one or more serial
ports to send SNMP traps.
See “SNMP Trap Notifications Entry” on page 312
To Next Page
Loading...
