AlterPath ACS Installation, Administration, and User’s Guide 251
T To Enable or Disable Serial Ports
1 Go to Ports > Physical Ports, and select a port or ports to modify.
2 To enable selected ports, click the “Enable Selected Ports” button.
3 To disable selected ports, click the “Disable Selected Ports” button.
Note: By default, all Serial Ports are disabled from the factory. The Administrator
can activate and assign specific users to individual physical ports.
4 Click “apply changes.”
General
Under Ports > Physical Ports in Expert Mode, if you select one or more ports
from the ports list and click the Modify button, the General form appears as
shown in the following form.
To Configure Multiple Sessions and Port Sniffing for One or More Serial
Ports
Page 281
To Configure a Serial Port for IPDU or IPMI Power Management Page 285
To Configure a User for IPDU Power Management While Connected To a
Serial Port
Page 286
To Configure TCP Port Number, STTY Options, Break Interval, and the
Login Banner for a Serial Port Connected to a Console
Page 290
To Next Page
Loading...
