Ports Menu & Forms
290
T
To Configure TCP Port Number, STTY Options,
Break Interval, and the Login Banner for a Serial Port
Connected to a Console
1. Go to Ports > Physical Ports in Expert mode, and select a port or ports to
modify.
2. Select the “Other” tab.
3. To change the port number for the serial port, enter another number in the
“TCP Port” field.
4. To assign a name to the port’s IP address, enter an alias in the “Port IP
Alias” field. (Console connection protocol only)
5. If connecting to a Microsoft Windows Server 2003 operating system
through the Emergency Management Services (EMS) console, enable the
“Windows EMS”. (Console connection protocol only)
Login Banner
Enter the text you wish to appear as a
login banner when logging into a
terminal.
Host to Connect
This field should be populated with the
IP address of the device you are
connecting to. The field is displayed
when a terminal server (TS) profile is
selected from the “Connection
Protocol” drop-down menu on the
General form.
Terminal Type
This field should be populated with the
terminal type when connecting to a
host system. The field is displayed
when a terminal server (TS) profile is
selected from the “Connection
Protocol” drop-down menu on the
General form.
Field Name Definition
To Next Page
