Installation and Configuration
48
Selecting A Security Profile Using the Web Manager
After the initial configuration, connect to the Web Manager by entering the IP
address of the ACS in a supported browser.
Note: Once you login to the Web Manager, a Security Profile must be selected in
order to further configure ACS using the Web Manager. For this reason your
browser redirects to Wizard > Step1: Security Profiles.
T To Select a Security Profile
Select a pre-defined Security Profile, or define a Custom profile for specific
services. The profiles are:
• Secured: Disables all protocols except SSHv2, HTTPS, and SSH to
Serial Ports.
• Moderate: Enables SSHv1, SSHv2, HTTP, HTTPS, Telnet, SSH and
Raw connections to Serial Ports, ICMP, and HTTP redirection to
HTTPS.
• Open: Enables all services, Telnet, SSHv1, SSHv2, HTTP, HTTPS,
SNMP, RPC, ICMP and Telnet, SSH and Raw connections to Serial
Ports.
• Default: Sets the profile to the same configuration as Moderate
profile.
• Custom: Allows custom configuration of individual protocols and
services.
For detailed information on Security Profiles see “Security Profiles” on page
236.
The administrator can perform the following tasks using the Web Manager.
• Administer ACS and its connected devices.
• Configure user and group permissions.
• Access the serial ports and the connected devices.
To Next Page
Loading...
