AlterPath ACS Installation, Administration, and User’s Guide 47
Basic Installation Procedures
6. Enter the domain name.
7. Enter the IP address for the Primary DNS (domain name) server.
8. Enter the IP address for the gateway.
9. Enter the netmask for the subnetwork.
The network configuration parameters appear.
10. Enter y after the prompts shown in the following screen example.
11. To confirm the configuration, enter the ifconfig command.
12. After the initial configuration proceed to the Web Manager to select a
security profile as described in the following section.
Note: To use the Web Manager, ask your system administrator for the ACS’s IP
address. ACS may be set up with a static IP address at your site. By default,
ACS uses the IP address provided by the DHCP server. If your network does
not use DHCP, then ACS defaults to 192.168.160.10.
Domain name[cyclades.com]: domain_name
Primary DNS Server[192.168.44.21] :
DNS_server_IP_address
Gateway IP[eth0] : gateway_IP_address
Network Mask[#] : netmask
Are all these parameters correct? (y/n)[n]: y
Do you want to activate your configurations
now? (y/n)[y]: y
Do you want to save your configuration to
Flash? (y/n)[n]: y
To Next Page
Loading...
