AlterPath ACS Installation, Administration, and User’s Guide 293
Note: Clustering only works for ports that are configured as CAS profile.
You can use one ACS as the “master” unit to control other ACS units as
“slaves”. The ports on the slave unit(s) appears as if they are part of the master
unit.
Note: Multiple IPDUs should only be connected and daisy-chained through the
serial port of the master ACS unit when you are configuring a cluster.
This section shows you how to define and configure the slaves.
When you click the “Add” or “Edit” button on the Ports > Virtual Ports form,
the following dialog box appears.
Figure 10-33: Expert > Ports > Virtual Ports > New/Modify Port Dialog Box
The following table describes the fields available in the Virtual Ports New/
Modify Port dialog box.
To Next Page
