AlterPath ACS Installation, Administration, and User’s Guide 117
Description of Forms in Expert Mode
Table 6-5: Expert > Ports
Menu Selection Use this menu to: Where Documented
Physical Ports
Activates or deactivates serial ports.
Set the parameters for each or all
ports. Configure specific parameters
for the serial ports where IPDU
devices are connected.
Chapter 10, Page 249
Virtual Ports
Perform Clustering. One ACS can be
used as a Master to control other
ACS (slaves) units. All ports of the
slave unit appear as if they are in the
master unit. This section shows how
to define and configure the slaves.
Chapter 10, Page 292
Port Status
View the current status of each port.
The information provided here are:
RS232 Signal Status and user
connected to each port.
Chapter 10, Page 298
Ports Statistics
View information on the data
reception Rx bytes and transmission
Tx bytes on each physical port. View
current CAS user(s), Baud rate,
frame, parity, break and overruns.
Chapter 10, Page 299
Table 6-6: Administration
Menu Selection Use this menu to: Where Documented
System Information
View
information on the system
hardware, version, file system
and PCMCIA cards loaded
Chapter 11, Page 302
To Next Page
Loading...
