Configuring the ACS in Expert Mode
118
Notifications
Configure the alarm strings and the
destination of the notification. ACS
can send notification by email,
pager or SNMP trap in the
occurrence of any system warnings
and alarms.
Chapter 11, Page 305
Time/Date
Set the timezone and configure the
system’s Date and Time.
Network Time Protocol (NTP) can
also be used.
Chapter 11, Page 315
Boot Configuration
Configure ACS to boot from its
internal firmware or from the
network.
Defines the settings for loading the
operating system in the event that
the ACS fails to boot successfully.
The AlterPath ACS can boot from
its internal firmware or from the
network. This section configures
the required parameters.
Chapter 11, Page 317
Backup Configuration
Use a FTP server to save and
retrieve your ACS configuration;
use a storage device to store your
configuration.
Chapter 11, Page 320
Upgrade Firmware
Upload/upgrade new firmware. Chapter 11, Page 323
Reboot
Reboot the ACS system. Chapter 11, Page 326
Online Help
Configure a path to a local server
for storing the online help files.
Chapter 11, Page 327
Table 6-6: Administration
Menu Selection Use this menu to: Where Documented
To Next Page
Loading...
