Cyclades AlterPath ACS - To Configure a CDMA PCMCIA Card

Network Menu & Forms
182
T
To Configure a CDMA PCMCIA Card
1. Install the CDMA card and select “CDMA” from the pull-down menu on
the PCMCIA Management form.
2. In the “Local IP” field, enter the local IP address.
3. In the “Remote IP” field, enter the remote IP address.
4. Form the “Speed” pull-down menu, select the speed defined by the
specifications of the CDMA card you are using.
5. In the “Additional Initialization” field, enter additional parameters if
required by the card.
6. To enable call back, do the following:
a. Check the “Call Back” check box.
The “Phone Number” field appears on the Slot dialog box.
b. Enter a number for the ACS to use to call back the CDMA card.
7. Click OK.
8. Click “apply changes.”
Additional
Initialization
Additional initialization parameter to be sent to
the card. CDMA configuration has a default
command sequence to initialize the card, but if
additional initialization command is required
by the card, it will be added to default
command sequence. For example, additional
initialization parameters may be required in
communication networks of some countries.
Call Back
Check box to enable the callback security
feature
Phone Number
The phone number that ACS uses to call back.
Field Name Definition