AlterPath ACS Installation, Administration, and User’s Guide 239
Table 9-7: Expert > Enabled protocols for each security profile shown with a check mark.
1-The Default security profile parameters is the same as Moderate profile.
The first step in configuring your AlterPath ACS is to define a Security
Profile. One of the following situations is applicable when you boot up the
ACS unit.
1. ACS is starting for the first time, or after a reset to factory default
parameters.
In this situation when you boot ACS up and login as an administrator to
the Web Manager, a security warning dialog box appears. The Web
Manager is redirected to “Step1: Security Profile” in the Wizard mode.
Further navigation to other sections of the Web Manager is not possible
without selecting or configuring a Security Profile. Once you select or
configure a Security Profile and save the changes ACS restarts.
2. ACS firmware is upgraded and the system is restarting with the new
firmware.
In this situation the ACS was already in use and certain configuration
parameters were saved in the flash memory. In this case ACS
automatically retrieves the “Custom Security Profile” parameters saved in
the flash memory and behaves as it was a normal reboot.
3. ACS is restarting normally.
In this situation the system detects the pre-defined security profile. You
can continue working in the Web Manager.
Other Services Secure Moderate Open
Default
1
Custom
SNMP
3
RPC
3
ICMP
333
FTP
IPSec
User Configurable
To Next Page
Loading...
