AlterPath ACS Installation, Administration, and User’s Guide 51
Installing PCMCIA Cards
Installing PCMCIA Cards
The front panel of the ACS has two PCMCIA card slots as shown in the
following figure. You can insert and configure one card in each of the slots.
Figure 2-3: Front Panel PCMCIA Card Slots
To see a list of supported PCMCIA cards go to http://www.cyclades.com/
products/3/alterpath_acs, or www.cyclades.com > Products > IT
Infrastructure Management > AlterPath ACS > Click here for a list of
supported PCMCIA cards.
T To Install a PCMCIA Card
1. Insert the PCMCIA card into slot 1 or slot 2.
2. Use the Web Manager to configure the PCMCIA card.
Note: A hard disk PCMCIA card is automatically mounted once it is inserted, and it
needs no configuration.
T To Remove a PCMCIA Card
Caution: Always use the Web Manager to eject a PCMCIA card. Any other method
may cause a kernel panic.
1. Eject the card by using the Eject button on the Web Manager’s PCMCIA
Management form, Expert > Network > PCMCIA Management > Eject
To Next Page
Loading...
