AlterPath ACS Installation, Administration, and User’s Guide 45
Basic Installation Procedures
Figure 2-2: Security Advisory Console Message
T To Use the wiz Command to Configure Network Parameters
1. Launch the Configuration Wizard by entering the wiz command.
As shown in the sample screen below, the system brings up the
configuration wizard banner and begins running the wizard.
Important - Security Advisory!
Console Management provides critical access to management
features of attached equipment. Please take the required precautions
to understand the potential impacts this device may have to your
SECURITY policies.
From factory, this device is configured as follows:
• Single password for ROOT;
• All serial port DISABLED;
• DHCP, Telnet, SSHv1 & SSHv2, and HTTP & HTTPS enabled.
Cyclades STRONGLY recommends:
1. To change the ROOT password before setting up the box for
secure access to the ACS equipment.
2. That you SELECT A SECURITY PROFILE to complete the
INITIAL SETUP. Security is dependent on Policy and is
Configurable to fit in environments with varying levels of Security.
Cyclades provides three pre-set Security Levels: SECURED,
MODERATE and OPEN, and in addition, the ability to set a
CUSTOM Security Profile.
3. Do not leave the equipment idle WITHOUT selecting a
SECURITY PROFILE.
4. To ENABLE Serial Ports and CONFIGURE them using Web UI
or CLI. Refer to the Quick Start Guide or the User's Guide for
Security Profile selection details and Serial Port configuration.
[root@CAS root]# wiz
To Next Page
Loading...
