Applications Menu & Forms
148
T
To Delete, Add, or Edit an IPMI Device to Enable or Disable
IPMI Power Management
1. Go to Applications> IPMI Power Mgmt.
The IPMI Power Management form appears.
2. To delete a previously added IPMI device, click the “Delete” button on
the line with the device’s name.
3. To add a device, click the “Add” button, and perform the following steps.
a. Enter an alias for the device in the “Alias:” field, if desired.
b. Enter the IP address of the IPMI device in the “IP Address” field.
c. Choose an authentication type, if desired, from the “Authentication
Type” pull-down menu.
d. Choose a user permission type from the “Access Level” pull-down
menu.
The default is “User.”
e. Enter a Username.
When the status is unknown, a question mark appears
instead of the light bulb. A question mark indicates
either of the following conditions.
• The device was added or deleted and the changes
were not saved.
• The device did not answer IPMI requests.
Turn power briefly off and then on again
Add and configure a new IPMI device.
Select an IPMI device to review or change its
configuration.
Delete an IPMI device.
Button Purpose
To Next Page
Loading...
