Cyclades AlterPath ACS - Page 28

Procedures
xxviii
T
To configure the Network Settings............................................................93
T
To Set Parameters for All Serial Ports.......................................................96
T
To Add a User..........................................................................................100
T
To Delete a User ......................................................................................101
T
To Change a Password.............................................................................101
T
To Configure Data Buffering...................................................................106
T
To Add a Syslog Server...........................................................................108
T
To Delete a Syslog Server........................................................................109
T
To Connect to the ACS............................................................................125
T
To Connect to a Device Through a Serial Port........................................126
T
To View Status, Lock, Unlock, Rename, or Cycle Power Outlets..........129
T
To View and Reset IPDU Information ....................................................132
T
To Configure Users to Manage Power Outlets on IPDUs.......................134
T
To Specify IPDU Names, Alarms, Syslogging........................................136
T
To Download AlterPath PM Software From Cyclades............................138
T
To Upgrade Software on an AlterPath PM..............................................139
T
To Power On or Power Off a Group of Outlets in the Same Power State143
T
To Power On or Power Off a Group of Outlets in Different Power State143
T
To Lock or Unlock a Group of Outlets in the Same Power State............144
T
To Lock or Unlock a Group of Outlets in Different Lock States ............144
T
To Turn the Power of a Group of Outlets Off and On Again..................144
T
To Enable or Disable IPMI Power Management.....................................148
T
To Manage Power on an IPMI Device ....................................................149
T
To Configure a Serial Port for IPDU or IPMI Power Management........149
T
To Configure a User for IPDU Power Management ...............................151
T
To enable IPMI Power Management of an IPMI device.........................152
T
To Create a Menu for a Local Computer Terminal .................................154
T
To Configure Host Settings [Expert].......................................................162
T
To Configure Syslogging for Serial Ports and Message Filtering ......165
T
To Configure a PCMCIA Card................................................................166
T
To Configure a Modem PCMCIA Card...................................................171
T
To Configure an ISDN PCMCIA Card...................................................172
T
To Configure a GSM PCMCIA Card ......................................................175
T
To Configure an Ethernet PCMCIA Card ...............................................177