POWER STEERING GEAR 6C–7
DAEWOO M-150 BL2
D105C536
6. Remove the packing (5).
D15C537A
Installation Procedure
1. Install in the reverse order of removal.
2. Install the power steering gear bracket with the bolt.
Tighten
Tighten the bracket bolts to 50–55 NSm (36–41 lb-ft).
D15C512A
21–35 NSm
21–35 NSm
3. Connect the steering pipe. Refer to Section 6A, Pow-
er Steering System.
Tighten
Tighten the power steering pressure line fitting (1) to
21–35 NSm (16–25 lb-ft) (1).
Tighten the return line fitting to 21–35 NSm (16–25 lb-
ft) (2).
Important: When adding fluid or making a complete
fluid change, always use DEXRONR II or III power
steering fluid. Failure to use the proper fluid will cause
hose and seal change and fluid leaks.
4. Fill the fluid reservoir with power steering fluid.
5. Inspect for leaks. If there are leaks, correct the cause
of the leaks and bleed the system. Refer to Section
6A, Power Steering System.
POWER STEERING GEAR RACK
AND PINION BOOT
Refer to Section 6D, Manual Steering Gear.
To Next Page
Loading...
