Configuring System Information 111
•
End Day
— Select the ending day number. This field displays only when the Recurring check box is
selected.
•
End Month
— Select the ending month.
•
End Time
— Select the ending time in hh:mm format.
•
End Date
— Select the ending date. This field displays only when the Recurring check box is cleared.
•
End Year
. — Select the ending year. This field displays only when the Recurring check box is cleared.
•
Offset
— Set the number of minutes to add during summer time in the range 0 to 1440.
•
Zone
— Set the acronym of the time zone to be displayed when summer time is in effect.
Defining the Summer Time Parameters
1.
Open the
Summer Time Configuration
page.
2.
Define the
fields as needed.
3.
Click
Apply Changes
.
The summer time settings are modified, and the device is updated.
Configuring Summer Time Parameters Using CLI Commands
For information about the CLI commands that perform this function, see the
Clock Commands
chapter
in the
CLI Reference Guide
. The following table summarizes the equivalent CLI commands you use to
configure summer time parameters.
Clock Detail
Use the Clock Detail page to set the time and date or view information about the current time, time
zone, and summer time settings.
To display the Clock Detail page, click System
→
General
→
Clock Detail in the tree view.
Table 6-6. Summer Time Parameters Commands
CLI Command Description
clock summer-time recurring Sets the summertime offset to UTC recursively every year.
clock summer-time date Sets the summertime offset to UTC.
no clock summer-time Resets the recurring summertime configuration.
To Next Page
Loading...
