Dell PowerConnect 8024 User Guide

Introduction 19
1
Introduction
This section describes the switch user-configurable features. For a list of all features, see the software
version release notes.
NOTE: Before proceeding, read the release notes for this product. You can download the release notes from
the Dell Support website, support.dell.com/manuals.
The Dell™ PowerConnect™ 8024/8024F series are standalone Layer 2 and 3 switches that extend the
Dell PowerConnect LAN switching product range. These switches include the following features:
• 1U form factor, rack-mountable chassis design.
• Support for all data-communication requirements for a multi-layer switch, including layer 2
switching, IPv4 routing, IPv6 routing, IP multicast, quality of service, security, and system
management features.
• High availability with hot swappable subordinate switches.
The topics covered in this section include:
•System Features
• Switching Features
• Routing Features
•IPv6
• Quality of Service Features
•Multicast Features
• Command-Line Interface Documentation

Dell PowerConnect 8024 Specifications

General

Switching Capacity	480 Gbps
Stackable	Yes
Device Type	Switch
Enclosure Type	Rack-mountable
Power Redundancy	Optional
Width	17.3 in
Height	1.7 in
Jumbo Frame Support	Yes
Ports	24 x 10 Gigabit SFP+
Management	Web-based GUI, Command Line Interface (CLI), SNMP
VLAN Support	Yes
Power Supply	Internal
Routing Protocol	Static routing
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Temperature	0 to 45 °C
Storage Temperature	-20 to 70 °C
Relative Humidity	10% to 90% (non-condensing)
MAC Address Table Size	32, 000 entries