EasyManuals Logo

Dell PowerConnect 8024 User Guide

Dell PowerConnect 8024
778 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #724 background imageLoading...
Page #724 background image
724 Configuring IP Multicast
Setting the IGMP Mode
1.
Open the
IGMP Global Configuration
page.
2.
Set
Admin Mode
to Enable or Disable, to turn IGMP on or off.
3.
Click
Apply Changes
.
The IGMP configuration is saved, and the device is updated.
Setting IGMP Mode Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide:
IGMP Commands
The following table summarizes the equivalent CLI commands for this feature.
Routing Interface
The Routing Interface menu page contains links to web pages that configure and display IGMP routing
parameters and data. To display this page, click IPv4 Multicast
IGMP
Routing Interface in the tree
view. Following are the web pages accessible from this menu page:
IGMP Interface Configuration
IGMP Configuration Summary
•IGMP Cache Information
IGMP Interface Source List Information
IGMP Interface Configuration
Use the IGMP Interface Configuration
page to configure and/or display router interface parameters.
You must configure at least one valid routing interface before you can access this page and configure IP
Multicast IGMP.
To display the page, click IPv4 Multicast
IGMP
Routing Interface
Interface Configuration in the
tree view.
Table 12-14. IGMP Global Commands
CLI Command Description
ip igmp Sets the administrative mode of IGMP in the system to active.
show ip igmp Displays system-wide IGMP information.

Table of Contents

Other manuals for Dell PowerConnect 8024

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dell PowerConnect 8024 and is the answer not in the manual?

Dell PowerConnect 8024 Specifications

General IconGeneral
Switching Capacity480 Gbps
StackableYes
Device TypeSwitch
Enclosure TypeRack-mountable
Power RedundancyOptional
Width17.3 in
Height1.7 in
Jumbo Frame SupportYes
Ports24 x 10 Gigabit SFP+
ManagementWeb-based GUI, Command Line Interface (CLI), SNMP
VLAN SupportYes
Power SupplyInternal
Routing ProtocolStatic routing
FeaturesQuality of Service (QoS), VLAN support
Compliant StandardsIEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Temperature0 to 45 °C
Storage Temperature-20 to 70 °C
Relative Humidity10% to 90% (non-condensing)
MAC Address Table Size32, 000 entries

Related product manuals