Dell PowerConnect 8024 - Start Operational Code; Change the Baud Rate

84 Configuring Dell™ PowerConnect™
1 - Start operational code
2 - Change baud rate
3 - Retrieve event log using XMODEM
4 - Load new operational code using XMODEM
5 - Display operational code vital product data
6 - Abort boot code update
7 - Update boot code
8 - Delete backup image
9 - Reset the system
10 - Restore configuration to factory defaults (delete config files)
11 - Activate Backup Image
12 - Password Recovery Procedure
13 - Reformat and restore file system
The following sections describe the Boot menu options.
Start Operational Code
Use option 1 to resume loading the operational code.
To relaunch the boot process from the Boot menu, select 1 on the Boot menu and press <Enter>.
The following prompt displays:
Operational Code Date: Tue Apr 29 10:15:36 2008
Uncompressing.....
50% 100%
|||||||||||||||||||||||||||||||||||||||||||||||||||
Change the Baud Rate
Use option 2 to change the baud rate of the serial interface.
To change the baud rate from the Boot menu:
1.
On the Boot menu, select 2 and press <Enter>.
The following prompt displays:
[Boot Menu]2
Select baud rate: