Dell PowerConnect 8024 User Guide

Configuring System Information 247
• Agent Address — The IP address associated with this agent.
Configuring and Viewing sFlow Settings Using CLI Commands
For information about the CLI commands that perform this function, see the Flow Commands chapter
in the
CLI Reference Guide . The following table summarizes the equivalent CLI commands you use to
configure and view sFlow settings.
sFlow Receiver Configuration
Use the sFlow Receiver Configuration page to configure the sFlow Receiver.
To access the sFlow Receiver Configuration page, click System
→ sFlow → Receiver Configuration in the
navigation tree.
Figure 6-117. sFlow Receiver Configuration
The sFlow Receiver Configuration page contains the following fields:
• Receiver Index — Selects the receiver for which data is to be displayed or configured. The allowed
range is 1 to 8.
Table 6-58. sFlow Settings Commands
CLI Command Description
show sflow agent Displays the sflow agent information.

Dell PowerConnect 8024 Specifications

General

Switching Capacity	480 Gbps
Stackable	Yes
Device Type	Switch
Enclosure Type	Rack-mountable
Power Redundancy	Optional
Width	17.3 in
Height	1.7 in
Jumbo Frame Support	Yes
Ports	24 x 10 Gigabit SFP+
Management	Web-based GUI, Command Line Interface (CLI), SNMP
VLAN Support	Yes
Power Supply	Internal
Routing Protocol	Static routing
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Temperature	0 to 45 °C
Storage Temperature	-20 to 70 °C
Relative Humidity	10% to 90% (non-condensing)
MAC Address Table Size	32, 000 entries