Dell PowerConnect 8024 - Communities

Configuring System Information 217
4. Check the Remove check box.
5. Click Apply Changes .
The entry is removed, and the device is updated.
Defining SNMP Users Using CLI Commands
For information about the CLI commands that perform this function, see the SNMP Commands chapter
in the
CLI Reference Guide. The following table summarizes the equivalent CLI commands you use to
define SNMP users.
Communities
Access rights are managed by defining communities on the SNMPv1, 2 Community page. When the
community names are changed, access rights are also changed. SNMP Communities are defined only for
SNMP v1 and SNMP v2.
To display the SNMPv1, 2 Community page, click System
→ SNMP → Communities in the tree view.
Figure 6-97. SNMPv1, 2 Community
The SNMPv1, 2 Community page contains the following fields:
Table 6-44. SNMP Users Commands
CLI Command Description
show snmp users Displays the configuration of users.
snmp-server user Configures a new SNMP Version 3 user.