Configuring System Information 133
Figure 6-24. Add DNS Server
3.
Define the relevant fields.
4.
Click
Apply Changes
.
The new DNS server is defined, and the device is updated.
Configuring DNS Servers Using CLI Commands
For information about the CLI commands that perform this function, see the
IP Addressing Commands
chapter in the
CLI Reference Guide
. The following table summarizes the equivalent CLI commands you
use to configure DNS servers.
Default Domain Name
Use the Default Domain Name
page
to view and define default DNS domain names.
To display the Default Domain Name
page, click System
→
IP Addressing
→
Default Domain Name.
Figure 6-25. Default Domain Name
Table 6-16. DNS Servers Commands
CLI Command Description
ip domain-lookup Use to enable IP DNS-based host name-to-address translation.
ip name-server Configures available name servers.
To Next Page
Loading...
