Dell PowerConnect 8024 User Guide

532 Configuring Routing
• Iftransit Delay Interval (secs) — The OSPF Transit Delay for the virtual link in units of seconds. It
specifies the estimated number of seconds it takes to transmit a link state update packet over this
interface.
Displaying the Virtual Link Summary Using CLI Commands
For information about the CLI command that performs this function, see the following chapter in the
CLI Reference Guide:
• OSPF Commands
The following table summarizes the equivalent CLI commands for this feature.
Route Redistribution Configuration
Use the OSPF Route Redistribution Configuration page to configure redistribution in OSPF for routes
learned through various protocols. You can choose to redistribute routes learned from all available
protocols or from selected ones.
To display the page, click Routing
→ OSPF → Route Redistribution Configuration in the tree view.
Table 9-16. OSPF Virtual Link Summary Command
CLI Command Description
show ip ospf virtual-link brief Displays the OSPF Virtual Interface information for all areas in the
system.

Dell PowerConnect 8024 Specifications

General

Switching Capacity	480 Gbps
Stackable	Yes
Device Type	Switch
Enclosure Type	Rack-mountable
Power Redundancy	Optional
Width	17.3 in
Height	1.7 in
Jumbo Frame Support	Yes
Ports	24 x 10 Gigabit SFP+
Management	Web-based GUI, Command Line Interface (CLI), SNMP
VLAN Support	Yes
Power Supply	Internal
Routing Protocol	Static routing
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Temperature	0 to 45 °C
Storage Temperature	-20 to 70 °C
Relative Humidity	10% to 90% (non-condensing)
MAC Address Table Size	32, 000 entries