162 Configuring System Information
Defining Line Passwords
1.
Open the
Line Password
page.
2.
Select device access through a Console, Telnet, or Secure Telnet (SSH) session.
3.
Define the
Line Password
field for the type of session you use to connect to the device.
4.
Confirm the
Line Password
.
5.
Click
Apply Changes
.
The line password for the type of session is defined, and the device is updated.
Assigning Line Passwords Using CLI Commands
For information about the CLI commands that perform this function, see the
AAA Commands
chapter
in the
CLI Reference Guide
. The following table summarizes the equivalent CLI commands you use.
Enable Password
Use the Enable Password page to set a local password to control access to normal and privilege levels.
To display the Enable Password page, click System
→
Management Security
→
Enable Password in the
tree view.
Figure 6-50. Enable Password
The Enable Password page contains the following fields:
Table 6-28. Line Passwords Commands
CLI Command Description
password Specifies the password for a line (console, telnet, or SSH).
To Next Page
Loading...
