Dell PowerConnect 8024 - Prefix Delegation Configuration

614 Configuring IPv6
3. Click the Delete box if deleting the DNS Server Address for this pool.
4. Click the Delete box if deleting the Domain Name for this pool.
5. Click the Delete Pool box if deleting the entire pool.
6. Click Apply Changes .
The pool or its parameter setting is deleted, and the device is updated.
Configuring DHCPv6 Pool Parameters Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide :
• DHCPv6 Commands
The following table summarizes the equivalent CLI commands for this feature.
Prefix Delegation Configuration
Use the Prefix Delegation Configuration page to configure a delegated prefix for a pool. At least one
pool must be created using DHCPv6 Pool Configuration before a delegated prefix can be configured.
To display the page, click IPv6
→ DHCPv6 → Prefix Delegation Configuration in the tree view.
Table 10-7. DHCPv6 Pool Configuration Commands
CLI Command Description
dns-server Sets the ipv6 DNS server address which is provided to a DHCPv6
client by the DHCPv6 server.
domain-name Sets the DNS domain name which is provided to a DHCPv6 client by
the DHCPv6 server.
ipv6 dhcp pool Enters IPv6 DHCP Pool Configuration mode.