Dell PowerConnect 8024 - Setting a Static Address on the Management Interface

Using Dell™ OpenManage™ Switch Administrator 39
4. To configure an ip address of 10.256.24.64, with a netmask of 255.255.248.0, and a gateway of
10.256.24.1, type the following:
ip address 10.256.24.64 255.255.248.0 10.256.24.1
5.
Ty p e exit .
6. Ty p e exit .
7. At the console# prompt, type show ip interface out-of-band and press <Enter>.
Setting a Static Address on the Management Interface
1. Ty p e enable at the console> prompt, and press <Enter>.
2. At the console# prompt, type config and press <Enter>.
3. Ty p e ip address none.
4. To configure an ip address of 10.256.24.64, with a netmask of 255.255.248.0, and a gateway of
10.256.24.1, type the following:
ip address 10.256.24.64 255.255.248.0
ip default-gateway 10.256.24.1
5.
Ty p e exit .
6. At the console# prompt, type show ip interface management and press <Enter>.