Configuring System Information 253
Figure 6-122. sFlow Poll Summary
Configuring and Viewing sFlow Settings Using CLI Commands
For information about the CLI commands that perform this function, see the
sFlow Commands
chapter
in the
CLI Reference Guide
. The following table summarizes the equivalent CLI commands you use to
configure and view sFlow settings.
Industry Standard Discovery Protocol
The Industry Standard Discovery Protocol (ISDP) is a proprietary Layer 2 network protocol that inter-
operates with Cisco
→
devices running the Cisco Discovery Protocol (CDP). ISDP is used to share
information between neighboring devices. The switch software participates in the CDP protocol and is
able to both discover and be discovered by other CDP-supporting devices.
The ISDP menu contains links to the following pages:
• ISDP Global Configuration
•Cache Table
• Interface Configuration
• ISDP Statistics
ISDP Global Configuration
From the ISDP Global Configuration page, you can configure the ISDP settings for the switch, such as
the administrative mode.
To access the ISDP Global Configuration page, click System
→
ISDP
→
Global Configuration in the
navigation tree.
Table 6-61. sFlow Poll Configuration Commands
CLI Command Description
sflow polling Enables a new sflow poller instance for the data source if rcvr_idx is
valid.
sflow polling (Interface Mode) Enable a new sflow poller instance for this data source if rcvr_idx is
valid.
To Next Page
Loading...
