Configuring Quality of Service 697
Figure 11-21. Auto VoIP Configuration
The Auto VoIP Configuration page contains the following fields:
•
Auto VoIP Mode
— Enables or Disables Auto VoIP mode. The default is Disable.
•
Traffic Class
— Displays the traffic class used for VoIP traffic.
Configuring Auto VoIP Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide:
• QoS Commands
The following table summarizes the equivalent CLI commands for this feature.
Auto VoIP Interface Configuration
Use the Auto VoIP Interface Configuration page to configure the Auto VoIP settings for each interface.
To display the Auto VoIP Configuration page, click Quality of Service
→
Auto VoIP
→
Interface
Configuration in the navigation menu.
Table 11-11. Auto VoIP Configuration Commands
CLI Command Description
switchport voice detect auto Enables the VoIP Profile on all the interfaces of the switch.
To Next Page
Loading...
