Dell PowerConnect 8024 User Guide

222 Configuring System Information
Removing a Filter
1. Open the Notification Filter page.
2. Click Show All .
The
Show Notification page displays.
3. Select the Filter Table entry.
4. Check Remove .
The filter entry is removed, and the device is updated.
Configuring Notification Filters Using CLI Commands
For information about the CLI commands that perform this function, see the SNMP Commands chapter
in the
CLI Reference Guide . The following table summarizes the equivalent CLI commands you use to
configure notification filters.
Notification Recipients
Use the Notification Recipients page to view information for defining filters that determine whether
traps are sent to specific users, and the trap type sent. SNMP notification filters provide the following
services:
• Identifying Management Trap Targets
•Trap Filtering
• Selecting Trap Generation Parameters
• Providing Access Control Checks
To display the Notification Recipients page, click System → SNMP → Notification Recipient in the tree
view.
Table 6-46. Notification Filters Configuration Commands
CLI Command Description
show snmp filters Displays the configuration of filters.
snmp-server filter Creates or updates an SNMP server filter entry.

Dell PowerConnect 8024 Specifications

General

Switching Capacity	480 Gbps
Stackable	Yes
Device Type	Switch
Enclosure Type	Rack-mountable
Power Redundancy	Optional
Width	17.3 in
Height	1.7 in
Jumbo Frame Support	Yes
Ports	24 x 10 Gigabit SFP+
Management	Web-based GUI, Command Line Interface (CLI), SNMP
VLAN Support	Yes
Power Supply	Internal
Routing Protocol	Static routing
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Temperature	0 to 45 °C
Storage Temperature	-20 to 70 °C
Relative Humidity	10% to 90% (non-condensing)
MAC Address Table Size	32, 000 entries