236 Configuring System Information
search for and download a configuration file from the server. If successful, it applies the configuration
file to the switch. After starting the Auto Configuration process, you can monitor the status of the
process by the messages in the Auto Configuration State and Retry Count fields.
•
Auto Save Mode
— Specifies whether to save the automatically downloaded configuration file to the
startup configuration.
–
Enable
— Automatically saves the configuration file to the startup configuration.
–
Disable
— Uses the configuration file as the running configuration only. When the switch reboots,
it will load the configuration from the startup configuration file.
•
Retry Count
— Indicates the number of times to attempt the auto configuration process during boot
up. The number of times the switch has attempted to contact the TFTP server during the current
Auto Configuration session.
•
Auto Configuration State —
Shows the current state of the Auto Configuration process.
Configuring Auto Configuration Using CLI Commands
For information about the CLI commands that perform this function, see the
Utility Commands - Auto
Config
chapter in the
CLI Reference Guide
. The following table summarizes the equivalent CLI
commands you use to configure Auto Configuring.
Trap Manager
Use the Trap Manager menus to configure traps flags and view the trap log. Click System
→
Trap
Manager in the tree view to display the Trap Manager page. Use this page to go to the following features:
•Trap Flags
• OSPFv2 Trap Flags
• OSPFv3 Trap Flags
•Trap Log
Table 6-53. Auto Configuration Commands
CLI Command Description
boot host auto-save Enables/disables automatically saving the downloaded configuration
on the switch.
boot host dhcp Enables/disables Auto Config on the switch.
boot host retry-count Set the number of attempts to download a configuration.
show boot Displays the current status of the Auto Config process.
To Next Page
Loading...
