Configuring IPv6 653
•
Interface Delay Interval (secs)
— The OSPF Transit Delay for the virtual link in units of seconds. It
specifies the estimated number of seconds it takes to transmit a link state update packet over this
interface.
Displaying OSPFv3 Virtual Link Summary Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide
:
• OSPFv3 Commands
The following table summarizes the equivalent CLI commands for this feature.
OSPFv3 Route Redistribution Configuration
Use the OSPFv3 Route Redistribution Configuration
page to configure route redistribution.
To display the page, click IPv6
→
OSPFv3
→
Route Redistribution Configuration in the tree view.
Table 10-23. OSPFv3 Virtual Link Summary Commands
CLI Command Description
show ipv6 ospf virtual-link brief Displays the OSPFV3 Virtual Interface information for all areas in the
system.
To Next Page
Loading...
