302 Configuring Switching Information
The following table summarizes the equivalent CLI commands for this feature.
Protected Port Configuration
Use the Protected Port Configuration page to specify a Layer 2 security feature, Private VLAN Edge
(PVE) ports, that provides port-based security between ports that are members of the same VLAN.
Traffic from protected ports is sent only to the uplink ports and cannot be sent to other ports within the
VLAN.
To display the Port Configuration page, click Switching
→
Ports
→
Protected Port Configuration in the
tree view.
Table 7-12. Port Configuration Commands
CLI Command Description
description Adds a description to an interface.
duplex Configures the full/half-duplex operation of a given Ethernet interface
when not using auto-negotiation.
interface ethernet Enters the interface configuration mode to configure an Ethernet type
interface.
interface range ethernet Enters the interface configuration mode to configure multiple
Ethernet type interfaces.
mtu Enables jumbo frames on an interface by adjusting the maximum size
of a packet or maximum transmission unit (MTU).
negotiation Enables auto-negotiation operation for the duplex parameters of a
given interface.
speed Configures the speed of a given Ethernet interface when not using
auto-negotiation.
show interfaces advertise Displays information about auto negotiation advertisement.
show interfaces configuration Displays the configuration for all configured interfaces.
show interfaces description Displays the description for all configured interfaces.
show interfaces detail Displays the detail for all configured interfaces.
show interfaces status Displays the status for all configured interfaces.
shutdown Disables interfaces.
To Next Page
Loading...
Need help?
General
