Configuring Quality of Service 693
Defining Interface Configuration Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide:
• QoS Commands
The following table summarizes the equivalent CLI commands for this feature.
Interface Queue Configuration
Use the
Interface Queue Configuration page to define what a particular queue does by configuring
switch egress queues. User-configurable parameters control the amount of bandwidth used by the queue,
the queue depth during times of congestion, and the scheduling of packet transmission from the set of
all queues on a port. Each port has its own CoS queue-related configuration.
The configuration process is simplified by allowing each CoS queue parameter to be configured globally
or per-port. A global configuration change is automatically applied to all ports in the system.
To display the
Interface Queue Configuration page, click Quality of Service
→
Class of Service
→
Interface Queue Configuration in the tree view.
Figure 11-19. Interface Queue Configuration
The Interface Queue Configuration page contains the following fields:
•
Interface
— Specifies the
Interface
(Unit/Port, LAG, or Global) that’s being configured.
Table 11-9. Interface Configuration Commands
CLI Command Description
traffic-shape Specifies the maximum transmission bandwidth limit for the interface
as a whole.
To Next Page
Loading...
