126 Configuring System Information
The log information is removed from the log file table, and the device is updated.
Displaying Log Information Using CLI Commands
For information about the CLI commands that perform this function, see the
Syslog Commands
chapter
in the
CLI Reference Guide
. The following table summarizes the equivalent CLI commands you use to
remove log information.
Log File
The Log File contains information about specific log entries, including the time the log was entered, the
log severity, and a description of the log.
To display the Log File, click System
→
Logs
→
Log File in the tree view.
Figure 6-18. Log File
The Log File Table page contains the following fields:
•
Log Index
— The Log Number within the
Log File Table
.
•
Severity
— The log severity.
•
Log Time
— The time at which the log was entered in the
Log File Table
.
•
Component
— The component being logged.
Table 6-12. Log Information Commands
CLI Command Description
clear logging Use to clear messages from the logging buffer.
show logging Displays the state of logging and the syslog messages stored in the
internal buffer.
To Next Page
Loading...
