220 Configuring System Information
Configuring Communities Using CLI Commands
For information about the CLI commands that perform this function, see the
SNMP Commands
chapter
in the
CLI Reference Guide
. The following table summarizes the equivalent CLI commands you use to
configure SNMP communities.
Notification Filter
Use the Notification Filter page to set filtering traps based on OIDs. Each OID is linked to a device
feature or a feature aspect. The Notification Filter page also allows you to filter notifications.
To display the Notification Filter page, click System
→
SNMP
→
Notification Filters in the
tree view
.
Figure 6-100. Notification Filter
The Notification Filter page contains the following fields:
•
Notification Filter Name —
Contains a list of user-defined notification filters. A notification filter
name can contain a maximum of 30 characters.
•
New Object Identifier Tree —
Displays the OID configured for the selected filter. This field can be
edited.
Table 6-45. SNMP Communities Commands
CLI Command Description
show snmp Displays the SNMP status.
snmp-server community Sets up the community access string to permit access to SNMP
protocol.
snmp-server community-group Maps SNMP v1 and v2 security models to the group name.
To Next Page
Loading...
