Dell PowerConnect 8024 User Guide

Configuring IPv6 655
4. Click Apply Changes .
The selected route redistribution is configured for OSPFv3, and the device is updated.
Configuring OSPFv3 Route Redistribution Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide :
• OSPFv3 Commands
The following table summarizes the equivalent CLI commands for this feature.
OSPFv3 Route Redistribution Summary
Use the OSPFv3 Route Redistribution Summary page to display route redistribution settings by source.
To display the page, click IPv6
→ OSPFv3 → Route Redistribution Summary in the tree view.
Table 10-24. OSPFv3 Route Redistribution Commands
CLI Command Description
redistribute Configures the OSPFv3 protocol to allow redistribution of routes from
the specified source protocol/routers.
distribute-list out Specifies the access list to filter routes received from the source
protocol.

Dell PowerConnect 8024 Specifications

General

Switching Capacity	480 Gbps
Stackable	Yes
Device Type	Switch
Enclosure Type	Rack-mountable
Power Redundancy	Optional
Width	17.3 in
Height	1.7 in
Jumbo Frame Support	Yes
Ports	24 x 10 Gigabit SFP+
Management	Web-based GUI, Command Line Interface (CLI), SNMP
VLAN Support	Yes
Power Supply	Internal
Routing Protocol	Static routing
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Temperature	0 to 45 °C
Storage Temperature	-20 to 70 °C
Relative Humidity	10% to 90% (non-condensing)
MAC Address Table Size	32, 000 entries