444 Configuring Switching Information
• DHCP Relay VLAN Configuration
DHCP Relay Global Configuration
Use this page to enable or disable the switch to act as a DHCP Relay agent. This functionality must also
be enabled on each port you want this service to operate on (see DHCP Relay Interface Configuration).
The switch can also be configured to relay requests only when the VLAN of the requesting client
corresponds to a service provider’s VLAN ID that has been enabled with the L2 DHCP relay
functionality (see DHCP Relay VLAN Configuration).
To access this page, click Switching
→
DHCP Relay
→
Global Configuration in the tree view.
Figure 7-125. DHCP Relay Global Configuration
If you enable or disable the DHCP Relay feature, click Apply Changes to submit the changes to system.
Configuring DHCP Relay With CLI Commands
For information about the CLI commands that perform this function, refer to the following chapter in
the
CLI Reference Guide
:
• L2 DHCP Relay Agent Commands
The following table summarizes the equivalent CLI commands for this feature.
Table 7-72. DHCP Relay Global Commands
CLI Command Description
dhcp l2relay Enables the Layer 2 DHCP Relay agent for an interface.
To Next Page
Loading...
