Dell PowerConnect 8024 - DAI VLAN Configuration

Configuring Switching Information 423
• Dynamic ARP Inspection Commands
The following table summarizes the equivalent CLI commands for this feature.
DAI VLAN Configuration
Use the DAI VLAN Configuration page to select the DAI-capable VLANs for which information is to be
displayed or configured.
To display the DAI VLAN Configuration page, click Switching
→ Dynamic ARP Inspection → VLAN
Configuration in the navigation tree.
Figure 7-108. Dynamic ARP Inspection VLAN Configuration
The Dynamic ARP Inspection VLAN Configuration page contains the following fields:
• VLAN ID — Select the VLAN ID for which information is to be displayed or configured.
•
Dynamic ARP Inspection — Select whether Dynamic ARP Inspection is Enabled or Disabled on this
VLAN. The default is Disable.
Table 7-59. Dynamic ARP Inspection Interface Commands
CLI Command Description
ip arp inspection limit Configures the rate limit and burst interval values for an interface.
ip arp inspection trust Configures an interface as trusted for Dynamic ARP Inspection.
show ip arp inspection interfaces Displays the Dynamic ARP Inspection configuration on all the DAI
enabled interfaces.