Configuring IP Multicast 741
The MLD Global Configuration page contains the following field:
•
Admin Mode
— Select Enable or Disable to set the MLD administrative status. The default is disable.
Click
Apply Changes
to send the updated configuration to the router. Configuration changes take
effect immediately. These changes will not be retained across a power cycle unless a save is performed.
Configuring MLD Global Settings Using CLI Commands
For information about the CLI command that performs this function, see the following chapter in the
CLI Reference Guide:
• IPv6 Routing Commands
The following table summarizes the equivalent CLI commands for this feature.
MLD Routing Interface Configuration
Use the MLD Routing Interface Configuration page to enable selected IPv6 router interfaces to
discover the presence of multicast listeners, the nodes who wish to receive the multicast data packets, on
its directly attached interfaces. To access this page, click IPv6 Multicast
→
MLD
→
Routing Interface
→
Interface Configuration in the navigation tree.
Figure 12-24. MLD Routing Interface Configuration
Table 12-23. IPv6 MLD Global Commands
CLI Command Description
ipv6 mld router Enables MLD in the router in global configuration mode and for a
specific interface in interface configuration mode.
To Next Page
Loading...
